Wrong area is calculated in BOM table with OE-NORM if length smaller than 400 and size constant in DACH profile. AUTODESK GRAPHIC LINE WITH ROUNDED ENDS WINDOWS 7Selecting a Plumbing Line on Windows 7 operating system may lead to crash. Plumbing Line overlapping with Plumbing fitting may lead to crash.Ĭhanging a Fitting Style on the Properties Palette may lead to the command line style control to not work. Some fittings may not appear correct when accessed thru a runtime catalog. Some fittings accessed thru Runtime catalog may not appear in Routing Preferences. Some Pipe created in previous versions of AutoCAD MEP snaps to fittings when opened. The Parallel Pipe command places new pipes on the wrong layer when systems use different layers. Pipe layouts with Very low slope cannot be created correctly. Fixing this means that an existing tool in which a specific number for percentage is stored will produce a different slope due to the new calculation. The formula for percentage slope by angle is incorrect. AUTODESK GRAPHIC LINE WITH ROUNDED ENDS PLUSRadiator valves are not aligned to the radiator when inserted using the plus grip. Radiator Import does not set property data properly. Radiator insertion fails, using the window option, if the radiator width or length is located in a basic table. Some linework is missing from certain MvParts. Opening drawings with large Xreferences may cause AutoCAD MEP to stop responding. Using Block Editor in a Panel Schedule drawing may lead to Circuits losing there name in the Schedule.īalloon notifications in Info Center may be blank when Windows 7 theme is set to classicĬompass repeatly sets Elevation value when Project Navigator is active. Wire sizes may not appear in the first time Circuit Manager is activated.ĮPD Relative Pathing may not work on mapped networked drives.Įxiting AutoCAD MEP with Circuit Manager open may lead to crash. Wire will only connect to one connector on some scaled devices.ĭuplicate circuits may be created when copying devices between two drawings.Ĭircuit Manager appears to hang in drawings with multiple tabs. Top and Bottom Elevation are incorrect in tooltip when duct height is greater than duct width.ĭuct Takeoffs may move or become disconnected during Regen Model.Įlbow may change elevation when changing parameters values.Ī crash may occur when closing a drawing with an EPD file that has a relative path.Ī crash may occur when converting multiple blocks to Devices. Takeoff for branch is not sized correctly when duct height is greater than duct width. Velocity in Duct Modify does not match the Velocity in the Properties Palette.Īdd Selected does not work correctly when duct height is greater than duct width. Haloed or hidden appearance for Plumbing Lines, Schematic lines and Wires do not display correctly.ĭuct Flanges are displayed incorrectly after moving a duct using grips. Layer Key Override - Devices with an assigned System Definition that contains a Layer Key Override are appending the initial overrides in the Layer Key Override dialog. AUTODESK GRAPHIC LINE WITH ROUNDED ENDS UPDATEWhen Rotating Devices with Update 1 installed, the Device annotation is not rotating relative to the offset specified in the block. Opening drawings from previous releases may lead to crash. The Add Automatic Property for a Device was not retrieving the Load Category or Number of Poles. Radiator Import may lead to crash during when updating existing drawings.ĭevice modify via grip edit doesn't move or maintain its orientation as expected. The following defects have been fixed in AutoCAD MEP 2010 Update 2: AUTODESK GRAPHIC LINE WITH ROUNDED ENDS PROFESSIONAL
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |